View source for GSPGPU:SetAxiConfigQoSMode

=Request=
{| class="wikitable" border="1"
|-
!  Index Word
!  Description
|-
| 0
| Header code [0x00100040]
|-
| 1
| Quality of service
|}

=Response=
{| class="wikitable" border="1"
|-
!  Index Word
!  Description
|-
| 0
| Header code
|-
| 1
| Result code
|}

=Quality of service=
{| class="wikitable" border="1"
|-
!  Index Bit
!  Description
|-
| 2-0
| [https://developer.arm.com/documentation/ddi0422/d/programmers-model/programmable-quality-of-service--progqos-/qos-tidemark-register Tidemark]
|-
| 15-8
| [https://developer.arm.com/documentation/ddi0422/d/programmers-model/programmable-quality-of-service--progqos-/qos-access-control-register Access control]
|} 

=Description=

This is used to program the QoS (Quality of Service). Tidemark is the maximum allowed number of transactions initiated but not completed with FCRAM, after which next transactions will be limited to certain masters. Access control sets which masters have this privilege. For more info, see [https://developer.arm.com/documentation/ddi0422/d/introduction/about-the-high-performance-matrix CoreLink™ NIC-301 r1p2].

Old systems have a total of 7 masters (guesses are ARM11, ARM9, GPU, DSP, CDMA, CSND, AHB); new systems have 3 additional masters (likely NewCDMA and L2 controller, and N3DS-GPU (enabled by [[CONFIG11_Registers#CFG11_GPU_N3DS_CNT|CFG11_GPU_N3DS_CNT]])).

GSP limits the maximum value of tidemark to 7; meanwhile, the maximum value for access control is 2^N-1, 1 bit for each slave interface, where N = number of slave interfaces.

New GSP forces SI7 (corresponding to N3DS-GPU) to be always set.