AES Registers: Difference between revisions
No edit summary |
|||
| Line 584: | Line 584: | ||
The contents of the keyslot specified in REG_AESKEYCNT can be updated by consecutively writing four words to REG_AESKEYXFIFO (keyX), REG_AESKEYYFIFO(keyY), or REG_AESKEYFIFO (normalkey). | The contents of the keyslot specified in REG_AESKEYCNT can be updated by consecutively writing four words to REG_AESKEYXFIFO (keyX), REG_AESKEYYFIFO(keyY), or REG_AESKEYFIFO (normalkey). | ||
After writing to a keyslot | After writing to a keyslot, the keyslot must be selected again(write REG_AESKEYSEL + set REG_AESCNT bit26), even when writing to the same keyslot. Writing the last word to a key FIFO immediately after selecting a keyslot will not affect the keyslot keydata that gets used at that time, the new keydata will not get used until the keyslot gets selected again. | ||
Writing to the key FIFOs with byte writes results in the AES engine converting the byte to a word for setting the key word, with this: word = (byteval) | (byteval<<8) | (byteval<<16) | (byteval<<24). The result is the same regardless of which FIFO register byte was written to. | Writing to the key FIFOs with byte writes results in the AES engine converting the byte to a word for setting the key word, with this: word = (byteval) | (byteval<<8) | (byteval<<16) | (byteval<<24). The result is the same regardless of which FIFO register byte was written to. | ||