CTRCARD Registers: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 7: | Line 7: | ||
| REG_CTRCARDCNT | | REG_CTRCARDCNT | ||
| 0x10004000 | | 0x10004000 | ||
| 4 | |||
|- | |||
| REG_CTRCARDBLKCNT | |||
| 0x10004004 | |||
| 4 | | 4 | ||
|- | |- | ||
| Line 67: | Line 71: | ||
=== Remarks === | === Remarks === | ||
Once reset is set high, it cannot be changed until controller is reset. | Once reset is set high, it cannot be changed until controller is reset. | ||
== REG_CTRCARDBLKCNT == | |||
{| class="wikitable" border="1" | |||
! BIT | |||
! DESCRIPTION | |||
|- | |||
| 15-0 | |||
| Total data blocks to transfer - 1 | |||
|- | |||
| 31-16 | |||
| Unused | |||
|} | |||
== REG_CTRCARDSECCNT == | == REG_CTRCARDSECCNT == | ||
Revision as of 23:44, 24 July 2013
Registers
| NAME | PHYSICAL ADDRESS | WIDTH |
|---|---|---|
| REG_CTRCARDCNT | 0x10004000 | 4 |
| REG_CTRCARDBLKCNT | 0x10004004 | 4 |
| REG_CTRCARDSECCNT | 0x10004008 | 4 |
| REG_CTRCARDSECSEED | 0x10004010 | 4 |
| REG_CTRCARDCMD | 0x10004020 | 16 |
| REG_CTRCARDFIFO | 0x10004030 | 4 |
REG_CTRCARDCNT
| BIT | DESCRIPTION |
|---|---|
| 3-0 | ? |
| 4 | CRC status (1=Error, 0=OK)? |
| 15-5 | ? |
| 19-16 | Transfer size (0=0 bytes, 1=4 bytes, 2=0x10 bytes, ...) |
| 23-20 | ? |
| 26-24 | Clock delay (0..5) |
| 27 | Data ready (1=Ready, 0=Busy) |
| 28 | Reset (1=High, 0=Low) |
| 29 | Transfer mode (1=Write, 0=Read) |
| 30 | Interrupt enable (1=Enable, 0=Disable) |
| 31 | Start (1=Busy, 0=Idle) |
Remarks
Once reset is set high, it cannot be changed until controller is reset.
REG_CTRCARDBLKCNT
| BIT | DESCRIPTION |
|---|---|
| 15-0 | Total data blocks to transfer - 1 |
| 31-16 | Unused |
REG_CTRCARDSECCNT
| BIT | DESCRIPTION |
|---|---|
| 2 | Latch key index |
| 9-8 | Key index |
| 15 | Latch seed |
REG_CTRCARDCMD
Specifies the 16-byte command to send. The command is split into 32-bit words, and stored as least significant word first, with each word itself in big-endian format.