Savegames
Encryption
On the 3DS savegames are stored much like on the DS, that is on a FLASH chip in the gamecart. On the DS these savegames were stored in plaintext but on the 3DS a layer of encryption was added. This is highly likely a streamcipher, as the contents of several savegames exhibit the odd behaviour that xor-ing certain parts of the savegame together will result in the plaintext appearing.
The reason this works is because the streamcipher used has a period of 512 bytes. That is to say, it will repeat the same keystream after 512 bytes. The way you encrypt with a streamcipher is you XOR your data with the keystream as it is produced. Unfortunately, if your streamcipher repeats and you are encrypting a known plaintext (in our case, zeroes) you are basically giving away your valuable keystream.
So how do you use this to decrypt a savegame on a 3DS? First off, you chunk up the savegame into 512 byte chunks. Then, you bin these chunks by their contents, discarding any that contain only FF. Now look for the most common chunk. This is your keystream. Now XOR the keystream with your original savegame and you should have a fully decrypted savegame. XOR with the keystream again to produce an encrypted savegame.
Wearleveling
The 3DS employs a wearleveling scheme on the savegame FLASH chips. This is done trough blockmaps. Depending on the size of the flashchip, these are located somewhere at the beginning of the flashchip, in the first sector. The structure is as follows:
struct sector_entry { uint8_t virt_sec; // Mapped to sector uint8_t prev_virt_sec; // Physical sector previously mapped to uint8_t phys_sec; // Mapped from sector uint8_t prev_phys_sec; // Virtual sector previously mapped to uint8_t virt_realloc_cnt; // Amount of times virtual sector has been remapped uint8_t phys_realloc_cnt; // Amount of times physical sector has been remapped uint8_t chksums[8]; } __attribute__((packed)); struct long_sector_entry { struct sector_entry sector; struct sector_entry dupe; uint32_t magic; };
With magic being a constant 0x080d6ce0.
Filesystem
Savefiles stored on the EEPROM are using a custom FS.
It is still unknown how to get correctly to the file table, but here is the file entry struct.
struct FileEntry { u32 Unknown; u8 FileName[0x10]; u32 EntryID; u32 Unknown; u32 Unknown; u32 FileSize; u32 Unknown; u32 Unknown; u32 Unknown; }