Registers
NAME
|
PHYSICAL ADDRESS
|
WIDTH
|
REG_RSACNT
|
0x1000B000
|
0x04
|
REG_RSASLOT0
|
0x1000B100
|
0x10
|
REG_RSASLOT1
|
0x1000B110
|
0x10
|
REG_RSASLOT2
|
0x1000B120
|
0x10
|
REG_RSASLOT3
|
0x1000B130
|
0x10
|
REG_RSAEXPFIFO
|
0x1000B200
|
0x04
|
REG_RSAMOD
|
0x1000B400
|
0x100
|
REG_RSATXT
|
0x1000B800
|
0x100
|
REG_RSACNT
Bit
|
Description
|
0
|
Start (1=Enable/Busy, 0=Idle)
|
1
|
Encrypt/Decrypt
|
4-7
|
Keyslot
|
8-9
|
Should be set to 0x3 before accessing REG_RSATXT and REG_RSAMOD
|
REG_RSASLOT
Start
|
Width
|
Description
|
0x0
|
0x4
|
REG_RSASLOTCNT
|
0x4
|
0x4
|
REG_RSASLOTSIZE
|
0x8
|
0x4
|
?
|
0xC
|
0x4
|
?
|
REG_RSASLOTCNT
Bits
|
Description
|
0
|
Key status (1=Key has been set, 0=Key has not been set yet)
|
1
|
Key write-protect
|
31-2
|
?
|
REG_RSASLOTSIZE
This contains the RSA size for this slot, in words. Normally this is 0x40 for RSA-2048.
REG_RSAEXPFIFO
The 0x100-byte private or public exponent is written to this write-only FIFO.
REG_RSAMOD
The RSA key modulo for the selected keyslot can be written here. When writing the RSA modulo, the modulo must align with the end of the register area.
REG_RSATXT
The RSA signature can be written here, and the data read from here is the message. When writing the RSA signature, the signature must be prepended with zeroes until it is a multiple of 8 bytes, and the end of the signature must align with the end of the register area.
The PKCS message padding must be manually checked by software, as hardware will only do raw RSA operations.
Keyslots usage
Keyslot
|
Description
|
0
|
Arbitrary
|
1
|
CXI access desc (following the exheader)
|
2-3
|
Unused
|