HID Codec "cdc:HID"

Command Header Description
0x00010000 GetData
0x00020000 Initialize
0x00030000 Finalize

Touchscreen

The touchscreen is the SPI device number 3, so it uses the 0x10142XXX SPI registers. It is initialized by issuing the following SPI commands:

spi_select_reg(3, 0x67);
spi_offset_mask(3, 0x26, 0x80, 0x80);
spi_select_reg(3, 0x67);
spi_offset_mask(3, 0x24, 0, 0x80);
spi_select_reg(3, 0x67);
spi_offset_mask(3, 0x25, 0x10, 0x3C);

Once the touchscreen is initialized, you can start polling touch data:

u8 raw_touchdata[0x40];
spi_select_reg(3, 0x67);
spi_read_offset(3, 0x26); //The return value of this is checked against "& 2"
spi_select_reg(3, 0xFB);
spi_read_offset_array(3, 1, raw_touchdata, 0x34);

This is the format of the touchdata report:

Offset Width Description
0x00 2*5 Five Touchscreen X Coordinates (big-endian MSB,LSB each. 12 bits number)
0x0A 2*5 Five Touchscreen Y Coordinates (big-endian MSB,LSB each. 12 bits number)
0x20 ?? ??

When the touchscreen is not touched, all the coordinates report 0xFFFF, and since touch coordinates have only 12 bits, you can check if the touchscreen is pressed by checking the 4th bit of the MSB. For example: pendown =Β !(raw_touchdata[0] & BIT(4))

MIC Codec "cdc:MIC"

Command Header Description

CSN Codec "cdc:CSN"

Command Header Description

DSP Codec "cdc:DSP"

Command Header Description

Legacy Codec "cdc:LGY"

Command Header Description

CHK Codec "cdc:CHK"

Command Header Description
0x000100C0 ReadSPI
0x000200C0
0x000300C2 WriteSPI
0x000400C2