516
edits
Changes
UNITINFO
| 4
| 4
|-
|-
| UNITINFO
| ENVINFO
| 0x1FF80014
| 0x1FF80014
| 1
| 1
|-
|-
| BOOT_FIRM
| UNITINFO
| 0x1FF80015
| 0x1FF80015
| 1
| 1
Normally this is the same as SYSCOREVER. This used by [[AM:InstallNATIVEFIRM]] for comparing with the NATIVE_FIRM titleID-low. When the low u8 from the NATIVE_FIRM titleID-low is larger than FIRMSYSCOREVER, [[AM:InstallNATIVEFIRM]] will trigger FIRM installing. When that u8 is not larger than FIRM_SYSCOREVER, and these two values don't match, [[AM:InstallNATIVEFIRM]] will return an error.
Normally this is the same as SYSCOREVER. This used by [[AM:InstallNATIVEFIRM]] for comparing with the NATIVE_FIRM titleID-low. When the low u8 from the NATIVE_FIRM titleID-low is larger than FIRMSYSCOREVER, [[AM:InstallNATIVEFIRM]] will trigger FIRM installing. When that u8 is not larger than FIRM_SYSCOREVER, and these two values don't match, [[AM:InstallNATIVEFIRM]] will return an error.
== UNITINFO ==
== ENVINFO ==
{| class="wikitable" border="1"
{| class="wikitable" border="1"
! Bit
! Bit
|}
|}
Bit1 in this field is set by the ARM11 kernel when ARM debug CP14 DSCR bit14 is set. [[NS]] loads the menu TID from MENUTID when bits 1-7 of this field are clear. [[ErrDisp]] will display development error info when bit0 is clear.
Bit1 in this field is set by the ARM11 kernel when ARM debug CP14 DSCR bit14 is set (halting debug-mode enabled). [[NS]] loads the menu TID from MENUTID when bits 1-7 of this field are clear. [[ErrDisp]] will display development error info when bit0 is clear.
== 0x1FF80015 ==
== 0x1FF80015 ==
|}
|}
The ARM11 loads this value from 0x1FFFFFF0+1 during startup, which is written by the ARM9 during ARM9<>ARM11 kernel sync.
The ARM11 loads the value of [[CONFIG_Registers#CFG_UNITINFO|CFG_UNITINFO]] from 0x1FFFFFF0+1 during startup, which is written by the ARM9 during ARM9<>ARM11 kernel sync.
When this field is zero, bit0 for UNITINFO is set for retail. When this field is non-zero, bit0 for UNITINFO is clear for dev/debug units, and an ARM11 kernel state flag which enables debugging is set. JTAG is only enabled for debugger and "firm" modes (bit1).
When this field is zero, bit0 for ENVINFO is set for retail. When this field is non-zero, bit0 for ENVINFO is clear for dev/debug units, and an ARM11 kernel state flag which enables debugging is set. JTAG is only enabled for debugger and "firm" modes (bit1).
== 0x1FF80016 ==
== PREV_FIRM ==
{| class="wikitable" border="1"
{| class="wikitable" border="1"
! Value
! Value