Difference between revisions of "DSP Memory Region"

From 3dbrew
Jump to navigation Jump to search
m
m
Line 23: Line 23:
 
8. Intermediate mix samples
 
8. Intermediate mix samples
  
9. Unknown Coefficients
+
9. Compressor table
  
 
10. DSP debug statistics
 
10. DSP debug statistics

Revision as of 12:12, 17 February 2016

Some of this is known to be incorrect. I'll correct this in a few months after a bit more RE work. Merry (talk) 21:10, 28 January 2016 (CET)


  • Note that everything below will vary depending on the exact DSP firmware used and different variants have slightly different behaviours.*

The DSP communicates with the application through two shared memory areas 0x8000 bytes long each (at 0x1FF50000 and 0x1FF70000 respectively). The DSP alternates between the use of these two areas (much like a double-buffer). Each area has 15 structures within it. The location of these structures can be obtained by reading channel 2 of the DSP pipe. A list of structures in the order the DSP addresses are read from the pipe follows:

1. Frame count

2. Input configurations

3. Input status

4. Input ADPCM coefficients

5. DSP configuration

6. DSP status

7. Output samples

8. Intermediate mix samples

9. Compressor table

10. DSP debug statistics

11. Unknown Coefficients

12. Unknown Coefficients

13. Unknown Coefficients

14. Unknown Coefficients

15. Unknown Coefficients

The DSP has 24 inputs, each of which are individually configurable. These 24 inputs each produce three sets of 4 audio channels (two left, two right).

These four audio channels feed into three intermediate mixers. Two of these intermediate mixers are used for effects and aux.

Channel Config

A 192 byte long structure. There are 24 of them.

Offset Type Description
0 u32 Dirty flags
4 70 bytes TODO
74 u16 Bitmap of which buffers in queue are dirty
76 Buffer[4] Buffer queue
156 u32 -
160 u16 Is Active
162 u16 Sync Count
164 8 TODO
172 u32 Physical address of current buffer
176 u32 Number of samples in current buffer
180 u16 bits[0:1]: 1 = mono, 2 = stereo; bits[2:3]: buffer format
182 u16 ADPCM predictor
184 s16 ADPCM yn1
186 s16 ADPCM yn2
188 u16 bit[0]: Has ADPCM data?; bit[1]: Is looping?
190 u16 Buffer Id of this current buffer

Buffer

Offset Type Description
0 u32 Physical Address
4 u32 Sample Count
8 u16 ADPCM P/S
10 s16[2] ADPCM yn[1,2]
14 u8 Has ADPCM?
15 u8 Looping?
16 u16 Buffer Id
18 u16 -

Simple Filter Configuration

This is a standard single-pole filter. The fall-off is 6dB per octave as you would expect.

Offset Type Description
0 s16 b0
0 s16 a1