RSA Registers

Revision as of 22:53, 14 August 2012 by Neimod (talk | contribs)

Registers

NAME PHYSICAL ADDRESS WIDTH
REG_RSACNT 0x1000B000 0x04
REG_RSASLOT0 0x1000B100 0x10
REG_RSASLOT1 0x1000B110 0x10
REG_RSASLOT2 0x1000B120 0x10
REG_RSASLOT3 0x1000B130 0x10
REG_RSAEXPFIFO 0x1000B200 0x04
REG_RSAMOD 0x1000B400 0x100
REG_RSATXT 0x1000B800 0x100

REG_RSACNT

Bit Description
0 Start (1=Enable/Busy, 0=Idle)
1 Encrypt/Decrypt
4-7 Keyslot
8-9 Should be set to 0x3 before accessing REG_RSATXT and REG_RSAMOD

REG_RSASLOT

Start Width Description
0x0 0x4 REG_RSASLOTCNT
0x4 0x4 REG_RSASLOTSIZE
0x8 0x4 ?
0xC 0x4 ?

REG_RSASLOTCNT

Bits Description
0 Key status (1=Key has been set, 0=Key has not been set yet)
1 Key write-protect
31-2 ?

REG_RSASLOTSIZE

This contains the RSA size for this slot, in words. Normally this is 0x40 for RSA-2048.

REG_RSAEXPFIFO

The 0x100-byte private or public exponent is written to this write-only FIFO.

REG_RSAMOD

The RSA key modulo for the selected keyslot can be written here. When writing the RSA modulo, the modulo must align with the end of the register area.

REG_RSATXT

The RSA signature can be written here, and the data read from here is the message. When writing the RSA signature, the signature must be prepended with zeroes until it is a multiple of 8 bytes, and the end of the signature must align with the end of the register area.

The PKCS message padding must be manually checked by software, as hardware will only do raw RSA operations.

Keyslots usage

Keyslot Description
0 Arbitrary
1 CXI access desc (following the exheader)
2-3 Unused