I2C Registers: Difference between revisions

← Older edit Newer edit →

@@ Line 406: / Line 406: @@
 | 0x61
 | 0x100
-| Reads/writes to an MCU u8 array, repeats after 0x100 bytes? The first byte is used to store flags for managing FIRM/NS state - bit1 = "LegacyPoweroff", bit4 = "LegacyJumpProhibited". bit2 causes the MCU driver (in mcu-module or LgyBg) to power off the system until next cold-boot. This register survives power-off, but does not seem to be saved to non-volatile storage (does not survive battery pulls). This register doesn't seem to actually control MCU behaviour by itself, it just seems to be used for storing arbitrary data.
+| Reads/writes to an MCU u8 array, repeats after 0x100 bytes? The first byte is used to store flags for managing FIRM/NS state - bit0 = "WirelessDisabled", bit1 = "SoftwareClosed", bit2 = "PowerOffInitiated", bit4 = "LegacyJumpProhibited". This register survives power-off, but does not seem to be saved to non-volatile storage (does not survive battery pulls). This register doesn't seem to actually control MCU behaviour by itself, it just seems to be used for storing arbitrary data.
 |}